I got my Cycle Visions vertical license plate, which fits on the rear axle. Installing requires removal of the rear axle and replacing the spacer with the CV bracket. When I removed the rear axle, I released the tension set screw on the left side only, installed the bracket (which was a bitch to get in, there is not much room in there), reinstalled the axle and reset the tension set screw. I measured the axle from both sides to make sure they were the same. The belt seems very tight but I did not check it before this project. I have ordered a tech manual for this bike but it has not arrived. I have three of questions to the guru's who know:
1. How tight should the drive belt be and what is the proper procedure to measure?
2. What would be the proper alignment procedure on this bike?
3. What should the rear axle be torqued at?
Thanks,
Cowboy