Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: 2018 TP diagram  (Read 5561 times)

0 Members and 1 Guest are viewing this topic.

Puzzled

  • Vendor
  • 5k CVO Member
  • *
  • Offline Offline
  • Posts: 8801
    • PA


    • CVO1: 2018 FLTRXSE Road Glide Custom (SOLD)
    • CVO2: 2013 FLTRXSE2 Road Glide Custom (SOLD)
    • CVO3: 2001 FLTRSEI2 Road Glide (SOLD)
2018 TP diagram
« on: December 04, 2022, 04:42:36 PM »

I have a 2018 here with the tp that has the color matched light bar trim.  I'm looking to take the painted surround off of the light to get repainted. Is this possible? Does the repair manual show that they separate?
« Last Edit: December 04, 2022, 08:47:04 PM by Puzzled »
Logged
2023 CVO Road Glide
2003 Rigid Springer Chopper "Puzzle" Bike 26"

OBB

  • 5k CVO Member
  • ***
  • Offline Offline
  • Posts: 5285
  • aka Ohiobellboy
    • OH


    • CVO1: 2011 Slate/Black SERGU** traded
    • CVO2: 2015 Double Blue SERGU
    • CVO3: 2012 SERG Blue
Re: 2018 TP diagram
« Reply #1 on: December 04, 2022, 07:19:18 PM »

It ain't coming apart. Tape the lens and paint it. That's what my guy did for my '15.

Sent from my SM-N981U using Tapatalk

Logged
PHOTOBUCKET IS HOLDING MY PIX HOSTAGE!!!

Puzzled

  • Vendor
  • 5k CVO Member
  • *
  • Offline Offline
  • Posts: 8801
    • PA


    • CVO1: 2018 FLTRXSE Road Glide Custom (SOLD)
    • CVO2: 2013 FLTRXSE2 Road Glide Custom (SOLD)
    • CVO3: 2001 FLTRSEI2 Road Glide (SOLD)
Re: 2018 TP diagram
« Reply #2 on: December 04, 2022, 08:46:24 PM »

It ain't coming apart. Tape the lens and paint it. That's what my guy did for my '15.

Sent from my SM-N981U using Tapatalk

I was able to get it apart however I don't think it was intended to come apart!.....
Logged
2023 CVO Road Glide
2003 Rigid Springer Chopper "Puzzle" Bike 26"

CVODON

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2421
    • FL

    • CVO1: 15 FLTRUSE
Re: 2018 TP diagram
« Reply #3 on: December 05, 2022, 10:07:03 AM »

I worked a few hours trying to get it apart and finally put it in oven at 170 degrees for 10 minutes and got it apart but I wouldn't do it again. Use quality 3M Fine line and tape it off. Be sure and scuff the plastic before painting or use a adhesion promoter if you want the paint to adhere and last for years. Tape it off, scuff or use adhesion promoter then retape to provide crisp lines, Apply color coat to area to be painted the remove tape and clearcoat the entire lamp.
Logged
 

Page created in 0.225 seconds with 20 queries.