Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Only hitting on front cylinder  (Read 5759 times)

0 Members and 1 Guest are viewing this topic.

Mr_Jobe

  • Newbie
  • *
  • Offline Offline
  • Posts: 4
  • www.CVOHARLEY.com
    • OK

Only hitting on front cylinder
« on: March 28, 2023, 09:21:56 AM »

04' has pretty much sat over winter.

Dead battery, so i hooked up the tender.

Was very hard to start. When it did there was an obvious issue.

Front cylinder was warm
Rear was cold.

Rear plug is wet.

I read a post that made me think i could have fried the...ECU?...charging the battery.

Any suggestions as to how to go about troubleshooting?

I have not checked the rear plug wire for spark yet.
Logged

Mr_Jobe

  • Newbie
  • *
  • Offline Offline
  • Posts: 4
  • www.CVOHARLEY.com
    • OK

Re: Only hitting on front cylinder
« Reply #1 on: March 29, 2023, 09:40:51 AM »

Just a FYI.

I just learned that, the Delphi F.I. in the twin cams requires compression in order to fire. Thats helpful to know when testing for spark.

Last night I:

Pulled both plugs, grounded to jugs, hit the start button and got a brief spark on the front then nothing on both.

Having been advised last night about a compression related issues:

I put both plugs back in, installed a couple old boat plugs i had, grounded to jugs and got fire on both plugs.

It would seem i simply need a new plug.
Logged

Landshark

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 601
    • CA


    • CVO1: 2006 FLSTF-SE
    • CVO2: 2009 FXDF-SE
    • CVO3: 2006 FLHTCU-SE
Re: Only hitting on front cylinder
« Reply #2 on: April 09, 2023, 07:03:48 PM »

Glad you have diagnosed the issue. Good luck and I hope that solves the problem.
Logged
 

Page created in 0.226 seconds with 24 queries.